12. OPERATION 12.2.3 STARTING IN COLD WEATHER (GAUGE PANEL SPECIFICATION) When starting in low temperatures, do as follows. NOTICE Do not keep the starting motor rotating continuously for more than 20 seconds. _ If the engine fails to start, waiting for about 2 minutes. repeat steps 2 and 3 after Pull fuel control lever 0 to LOW IDLING and HIGH IDLING. center position between Insert the key into starting switch 0, turn the key of start- HEAT OFF ing switch 0 to the HEAT position and hold it until glow signal 0 glows red. The preheating times are as shown below.
Ambient temperature Preheat time 0°C to -5°C - -5°C to -1 o’c I 15 seconds -10°C to -2o’c 30 seconds -2o’c to -30°C 45 seconds If the preheating time is too long or too short, the engine will not start easily. Observe the correct preheating time. When glow signal 0 becomes red, turn the key of starting switch 0 to the START position and start the engine. START 2-62