Komatsu — AFTER RUNNING OUT OF FUEL

. OPERATION TROUBLESHOOTING TROUBLESHOOTING PROCEDURE FOR BLEEDING AIR CAUTION air a 3 - 124 AFTER RUNNING OUT If you have run out of fuel, ad d fuel to the fuel tank and bleed ai r from the fuel system a The fuel injection pump and n ozzle of this engine consist of more pr ecise parts than the conve ntional ones. If foreign matter enters them, it can cause a tr ouble. Accordingly, if dust sticks to th e fuel system, wash it off w When opening the air bleedin g plug at the fuel filter head, take care. Fuel may spout because o 1. Fill the fuel tank with fuel . (1) at the fuel main filter head. 2. Loosen air bleeding plug 3.

Do not loosen the plug a it is loosened, air is not b Loosen wing bolt (3) whi (2). Move lever (4) up t the filter stand of the fuel prefilter. led. ch is fixing lever (4) of priming pum and down to let fuel flow out of 4. bleeding plug (1) until bu Tighten air bleeding plug bbles do not come out any more. (1) and then tighten wing bolt (3) y to lock lever (4). ir bleeding plug gm} wing screw .3kgm} ng switch to the START position a priming pump (2) securel Tightening torque for a 7.8 to 9.8Nm{0.8 to 1k Tightening torque for 6.9 to 12.7Nm{0.7 to 1 priming pump (2) securel Tightening torque for a 5. Turn the key in the starti start the engine.

When doing this, do not crank the starting motor continuous for more than 20 seconds . If the engine does not start, wait f at least 2 minutes, then try again. Perform this operation maximum of 4 times. 6. If the engine does not sta rt, repeat the procedure from Step