. MAINTENANCE SERVICE PROCEDURE REPLACE FUEL PREFILTER CARTRIDGE WARNING 4 - 56 After the engine has been o perated, all parts are at high temperature, so do not replace the filter im mediately. Wait for all parts to cool down before startin g the operation. inside the engine fuel piping system when the engine is running. High pressure is generated inside the engine fuel piping system when When replacing the filter, wait for at least 30 seconds after stopping th e engine to let the intern al pressure go down before replacing the filter. me close. Do not bring any fire or fla NOTICE Genuine Komatsu fuel filte r cartridges use a special filter that has hig hly efficient filtering abilit y.
When replacing the filter cartridge, always use a gen uine Komatsu part. The common rail fuel injec tion system used on this machine c onsists of more precise parts tha n the conventional injection pump and nozzle. If any part other than a gen uine Komatsu filter cartridge is used, dust or dirt may get in and cause problems with the injection system. Always avoid usin g substitute parts. When carrying out inspecti on or maintenance of the fuel system , pay m ore attention than normal to the entry of dirt. If dirt is stuck to any part, use fuel to wash it off completely. Container to catch the f Prepare a filter wrench 1. Close supply valve (1) of the fuel tank. 2.
Place a container unde r the fuel prefilter cartridge to catch the fuel. 3. Turn cup (3) of water separator installed at the bottom of the filter cartridge (2) to th e left and remove it. (This cup is used again.) 4. Using a filter wrench, t to remove it. 5. Install cup (3) to the bo urn filter cartridge (2) counterclockwise ttom of the new fuel pre-filter cartridge. (When doing this, alwa Tightening torque o ys replace the O-ring.) f cup: 10 Nm {1.0 kgm, 7.2 lbft} 6. Clean the filter holder.