FOOT PEDALS 4.2 Foot Pedal Replacement If the foot pedals or shaft need replacement due to dam- age or wear. Each pedal has it’s own shaft. 1 Raise the boom arms, engage the boom supports and shut off the engine. WARNING Never work under the boom arms without the boom supports engaged. Bolt 2 Remove the seat and hydrostatic shield. 3 Remove the bolt holding the linkage rod end to the pedal. (fig. C3563) 4 Remove bolts holding the center plate in place and remove the plate. (fig. C3565) 5 Remove the cap screw bolt retaining the foot pedal shaft to the side mount. 6 Remove and save any spacer washer if present.
7 Tip the inside end of the shaft up and remove the complete pedal and shaft assembly together. Keep count of the spacer washer used if present. 8 Replace worn parts as required. The foot pedals are equipped with bronze oillite bushings that are pressed into place and machined to size afterward. They are not serviceable separately. The complete pedal must be replaced. 9 Reinstall pedals in the reverse order. Total pedal movement side to side, end play, should not exceed 1/8”. C3563 4 Center Plate Bolt C3565 4-11