26 Airbag System 1 The front airbag mainly consists of three parts: Electronic control and monitoring device. Two front airbags with gas generators. The airbag fault warning light is located on the display screen of the information center of the combination instrument. The airbags are monitored by the electronic monitoring system of the airbag control unit. When the ignition switch is in the “ON” position, the airbag fault warning light will be lit for several seconds and then go out after self-detection is completed.
In the event of a serious frontal collision, the front airbags will act as a supplement to the three-point seat belt and protect the head and chest of the driver and the front passenger. The airbag system cannot replace the seat belt. It is only one part of the passive safety system of the vehicle. Please note: The airbag system can play its protective role to the greatest extent when the seat belt is correctly fastened and the headrest is correctly adjusted. Therefore, it is necessary to always wear a seat belt, not only to comply with regulations, but also to serve safety needs. The deployment or shrinkage of the frontal airbag is completed within a very short period of time.
The airbag cannot play a protective role against secondary impacts that may subsequently happen. To ensure that the frontal airbag can correctly deploy and unfold, there should be no blocking objects between the frontal airbag and the passenger. Caution Placing any subjects near or over the steering wheel, the dashboard and the airbag assembly, inside the dashboard, or above the passenger-side glove box is prohibited. This is because, when the vehicle is involved in a collision serious enough to deploy the airbag, these subjects will fly out and cause injuries. Caution Make sure to go to an authorized BAIC dealership to have the airbag system checked and repaired.
Do NOT try to refit the front bumper or any of the vehicle body structures on your own. Warning