Komatsu — STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS OPERATION MACHINE OPERATIONS AND CONTROLS 7. Check that charge and engine oil pressure monitor (6) goes off. 10 to -10 ° C (50 to 14 ° F) Change 0 to 20 below -10 ° C (14 ° F) 20 Breaking-in the New Machine NOTICE Your Komatsu machine has been thoroughly adjusted and tested before shipment from the factory. However, operating the machine under full load before breaking the machine in can adversely affect the performance and shorten the machine life. Be sure to break in the machine for the initial 100 hours (as indicated on the service meter).

Make sure that you fully understand the content of this manual, and pay careful attention to the following points when breaking in the machine. Run the engine at idle for 15 seconds after starting it. During this time, do not operate the control levers or fuel control dial. Idle the engine for 5 minutes after starting it up. Avoid operation with heavy loads or at high speeds. Immediately after starting the engine, avoid sudden starts, sudden acceleration, unnecessary sudden stops, and sudden changes in direction.

3 - 133 level monitor (5) Turbo pro tect function The turb o protect function is a function to prote ct the turbocharger by keeping the engine s peed at less than 1150 rpm imm ediately afte r the engine i s started. When the turbo protect function is actuated, positio n of the f uel control dial. When the turbo protect f unction i s actuated, th e engine s peed is held at less than 1150 rpm , even if the fuel control dial is operated . When the turbo protect f unction i s canceled, th e engine speed is set to the speed for the po sition of the fuel control dial. The r elationshi etween turbo protect function and t he temperature of the engine is as s hown in the table