Komatsu — TRAVELING ON SLOPES

. OPERATION MACHINE OPERATIONS AND CONTROLS TRAVELING ON SLOPES WARNING Turning or operating the work equipment when working on slopes may cause the machine to lose it balance and turn over, so avoid such 3 - 160 operations. Itis particularly dangerous to sw If such operations have to be per ing downhill when the bucket is loaded. formed, pile soil to make a platform (A) on the slope so the machine is k ept horizontal during operation. Do not work on a slope covered with the steel plates. Even with slight slopes there is a hazard that the machine may slip. p slopes. There is a danger that the approx. 20 to 30 cm (8 to 12 in) from the Do not travel up or down stee machine may turn over.

When traveling, raise the bucket ground. Do not travel downhill in reverse Never turn on slopes or travel ac Always go down to a flat place t . ross slopes. o perform these operations. It may be longer, but it will ensure safety. Always operate or travel in such a way that it is possible to stop safely at any time if the machine slips or becomes unstable. When traveling uphill, if the shoe s slip or it is impossible to travel uphill using only the force of the tracks , do not use the pulling force of the arm to help the machine travel uphill. There is danger that the machine may turn over. 1.

When traveling down steep hills, use the travel lever and fuel control dial to keep the trav a steep hill of more than 15 and set the work equipm diagram on the right, and lo el speed low. When traveling down °, with the sprocket (1) side down, ent to the posture shown in the wer the engine speed. REMARK Travel down fills with the sproc If the machine travels down with tends to become loose, and tha ket (1) side down. the sprocket (1) side up, the track t can cause skipping pitches.