Komatsu — BUCKET REPLACEMENT AND INVERSION

. OPERATION MACHINE OPERATIONS AND CONTROLS BUCKET REPLACEMENT AND INVERSION WARNING Replacement 1. Place the bucket in contact with a flat surface. 2. Remove the double nut on the stopper bolt for arm pin (A) and link pin (B), remove the bolt, pull out arm pin (A) and link pin (B), and then remove the bucket. 3. Align the arm (5) with holes (1) of the replacement bucket and the link (6) with holes (2), then insert grease-coated pins (A) and (B) into hole (1) and hole (2) respectively. (3) down to the regular groove. 4. Install the stopper bolts and nuts for each pin, then grease the pin. 3 - 165 When pins are knocked in with a hammer, pieces of metal may fly and cause seriou s injury.

When carrying out this operatio n, always wear goggles, hard hat, gloves, and other protective equ When the bucket is removed, p If pins are hit with a strong force , there is a hazard that the pin may fly ou t and i njure p eople in the sur rounding area. Make sure that there is no one in the surro unding area before starting the operation. When removing the pins, do not stand behind the bucket. In addition, be extremely ca reful not to put your foot under the b ucket while standing at the side for th e work. s, be extremely careful not to get your fingers caught. he pin holes when aligning the holes.

When removing or inserting pin s, be extremely careful not to get your f ingers caugh Never insert your fingers into t Stop the machine on a firm an d flat surface and do the work. When performing joint work, a ppoint a lead and f ollow that person's instructions and signals. REMARK When removing the pins, pla contact with the ground. ce the bucket so that it is in light ly to the ground, the resistance will cult to remove the pins. If the bucket is lowered strong be increased and it will be diffi NOTICE After removing the pins, make sure that mud or sand does not get on them. Dust seals are fitted at both ends o f the bushings, be careful not to damage them. REMARK reverse order to removal.

et (4), the O-rings (3) are easily Carry out installation in the When installing the buck ) on the boss of the arm (5) end as n knocking the pin, move the O-ring