Komatsu — DISCHARGED BATTERY

. OPERATION TROUBLES AND ACTIONS Booster Cable Connection Starting the Engine CAUTION 3 - 197 Keep the starting switch of the normal machine an d problem machine in th e OFF po Connect the boos ter cable as follows, in the order of the numbers marked in the dia 1. Connect the cl ip of booster cable (A) to the pos of battery (C) on the probl em machine. her end of booster 2. Connect the c lip at the ot positive (+) ter minal of bat tery (D) on the norm 3. Connect the cl ip of booster cable (B) to the neg of battery (D) on the norm 4.

Connect the o ther clip of frame (E) of th e problem m Always check that th e lock lever is set to the LOCK positi on, regardless of whether th e machine is working normally or ha s failed. Check also that all t he control lev ers are at the HOLD or neutral position. 1. Make sure the clips are fir mly connected to th e battery terminals . 2. Start engine o f the normal machine and run it at high idle speed. 3. Turn the starti ng switch of the problem machi ne to the START position and star t the engine. If the engine d oesn't start at first, try again aft er 2 minutes or so.

Booster Cable Disconnection After t he engine ha s started, di sconnect the booste r cables in the reverse of the order in which the y were connected. 1. Remove one clip of booster cable (B) from the (E) of the problem machine. 2. Remove the clip of booster cable (B) from t terminal of battery (D) on the normal machine 3. Remove the clip of booster cable (A) from terminal of battery (D) on the normal machine 4. Remove the clip of booster cable (A) from terminal of battery (C) on the problem machin 1. Remove one c lip of booste r cable (B) from the revolving frame he negative (-) . the positive (+) . the positive (+) e. (E ) of the prob lem machin e. er cable (B) from t 2.

Remove the clip of boost terminal of bat tery (D) on t he normal machine 3. Remove the clip of boos ter cable (A) from terminal of bat tery (D) on t he normal machine 4. Remove the clip of boos ter cable (A) from terminal of bat tery (C) on t he problem machin