Komatsu — MAINTENANCE INFORMATION

. MAINTENANCE MAINTENANCE INFORMATION MAINTENANCE INFORMATION Service Meter Reading Check the service meter reading every day to see if the time has come for any necessary maintenance to be performed. Komatsu Genuine Lubricants For lubrication of the machine, use the Komatsu genuine lubricants. Moreover use oil of the specified viscosity according to the ambient temperature.

4 - 2 Do not perform any i nspection and maintenance oper ation tha t is not foun Komatsu Genuine Re placement Parts Use Komatsu genuin e parts specified in the Parts Bo ok as replacement p Windshield Washer F luid Use automobile wind ow washer fluid, and be careful not to let any dirt get Fresh and Clean Lub ricants Use clean oil and gre ase. Also, keep the containers o f the oil a nd grease c lean. Keep foreign materials a way from oil and grease. Check Drained Oil an d Used Filter After oil is changed o r filters are replaced, check the old oil and fi lters for met al particles and for eign materia ls. If l arge quantity of metal pa suitable action.

rticles or foreign materials are found, always report to the person in charge, and carry out harge, carry Fuel Strainer Do not remove the s trainer from the filler port when a dding fue Welding Instructions Cut off power. Wa it for approx. one minute after tu rning off t he engine starting switch key , and then di sconnect the negative (-) te rminal of the battery. than 200 V continuously. g cable within 1 m (3.3 ft) of the area to be welded. If grounding cable is connected near ectors, etc., the instruments may malfunction. Do not apply more Connect groundin g cable within 1 m (3.3 instruments, conn ectors, etc., the instruments may malfunction.

If a seal or bearing happens to come between the p art being welded an d grounding point, change the g rounding point to avoid suc h parts. ea around the work equipment pins or the hydraulic cylinders as the grounding point. Do not use the ar ea around the work equipment pi ns or the hydraulic c ylinders as the gro unding point Do not Drop Things I nside Machine When opening ins pection windows or the oil filler p ort of the tank to car ry out inspection, be careful n ot to drop nuts, bolts, or tool If such things are lead to failure. If y s inside the machine.

dropped inside the machine, it ma y cause damage an d/or malfunction of the machine , an d will ou drop anything inside the mac hine, always remove it immediately. r inspection. Do not put unnece ssary things in your pockets. C arry only things whic h are necessary fo r inspection.