. MAINTENANCE MAINTENANCE PROCEDURE ADJUST BUCKET CLEARANCE WARNING 4 - 40 It is dangerou s if the work equip ment is mistakenl y moved whe n adjusting the bucket cle Set the work e quipment in a stab le condition, stop the engine, t hen set lock lever securely to the LOCK pos 1. Set the w ork equipmenti n the position sh own in the d iagram on the right LOCK p , then stop the engine and set the lock lever to the osition (L). ring (1) of the linkage and measure the amount of e "a". ment is easier of you move the bucket to one side ver to the 2. Shift O- clearanc Measure (right sid be meas Use a measure ide e of the diagram ) or the other s o all the clearance can ured in one pla 3.
Loosen 4 plate mounting bolts (2), and loosen plate (3). m is a split type, so the operation can be carried out emoving the bolts. The shi without r m is a split type emoving the bo 4. Remove as many shi "a". A pair of s of each shim i ms (4) corresponding to clearance shims composes one set and the s 0.5 mm (0.020 in). In case clearance amount thicknes amount (2) for th t and the clearance "a" is smaller tha e adjustment p n a shim, do not attempt to tighten bolt urpose. ). 5. Tighten the four bolts (2 If the bol for easie ts (2) are too stif f to tighten, pull out pin stopper bol t (5) r tightening.