. MAINTENANCE MAINTENANCE PROCEDURE without filling the pump case with hydraulic oil, there is danger that the pump may be prematurely air bleed plug. ENGINE 4) Tighten air bleeder (2) after air bleeding has been finished. 4 - 49 BLEEDING AIR FROM HYDRAULIC SYSTE For de tails, see "STAR TING ENGINE (PAGE 3-1 29)". If it is n ecessary to refer to the ite ms for starting t he en gine, movin g the machine of f, steering, or stopping, se 1. Bl eeding air from p NOTIC If the p damaged. Be sure to ble ) Loosen air ble ed plug (1) installed to th e drain port ompleted). and check that oil o ozes out (air bleeding is c ) After completio 2.
Bl eeding air betwe en pump and hydraulic ta NOTIC E If the e ngine is run at high speed without bleeding the ai r between the pump and hydraulic tank, ther e will be abnorma l generation o f heat , and this will lead to premature failure of the pu mp. ) Start the engin e and maintain it at a mid- range speed (PAGE 3-129)" ) Operate the wo rk equipment slowly for a pprox. 5 minutes 3. Bl eeding air from L his work is to be c onducted only when any o f the hydrauli c pump, valve and hoses i n the LS circuit i s replaced) NOTIC Unless air is bled from th e LS circuit, malfunction of th e work equipment ) Loosen air ble eder (2) installed at the LS port of the . for two minutes.
erate the bucket for approx. two minutes retraction to each stroke end). hydraulic pump ) Idle the engine ) Continue to op (extension and