Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4 - 53 7. Using the filter wrench, loo (7). sen ring nut (6) to remove casing 8. Remove screen (8) from the water separator table, pulling the screen out downward. fuel. 9. Wash screen (8) with clean At that time, also check it for damage and if any, replace it with a new one. (7) for damage, a crack or so bad 10. Wash the interior of casing a contamination as to make it impossible to identify the location of float (9), and if any of the m is found, replace the casing with a new one. er separator table. new one. ). 11. Install screen (8) on the wat 12. Replace O-ring (10) with a 13.

Screw in water drain plug (4 Tightening torque: 1.5 - 2.5 Nm (0.15 - 0.25 kgm, 1.1 - 1.8 lbft) 14. Put float (9) in casing (7) the way it does not tilt, and then pou clean fuel in the casing calm ly. 15. Install casing (7) on the wat er separator table and tighten ring nut (6). Tightening torque: 40 - 44 N m (4.0 - 4.4 kgm, 29.5 - 32.5 lbft) 16. 17. Connect drain hose (2). In case air intake plug (5) has been loosened to drain fuel tighten it now. Tightening torque: 8.0 - 12. 0 Nm (0.8 - 1.2 kgm, 5.8 - 8.7 lbft) 18. Turn fuel valve (3) to the "O PEN" position (O). on the right side of the machine. 19. Close pump room door (1) 20.

When the whole work is fini shed, bleed air from the water separator the same way a s when replacing th e fue filter cartridge. ure, see "Procedure for Bleeding Air (PAGE 3-190)". For the air bleeding proced ure, see "Procedure for Bleeding Air (PAGE