. MAINTENANCE MAINTENANCE PROCEDURE CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS, AFTERCOOLER FINS,FUEL COOLER FINS, AND AIR CONDITIONER CONDENSER FINS WARNING NOTICE 4 - 72 If compresse d air, high-pressure water, or s team hits your body directly o r dirt is sent flying by the com pressed air, high-pressure water, or stea m, there is danger of persona l injury. Always wear protectiv e glasses, dust m ask, and ot her protective equipment. When use th e compressed air, keep a dista nce from air nozzle, to preven ts damage to the To prevent d amage to the fins, apply comp ressed air from and appropria te distance . Damaged fins m ay cause water leaka ge or overheating.
In a dusty site, check the fins daily, irrespective of the maintenance interval. 1. Open th e engine hood and the bat tery inspection cover at th left side of the machine. move net (2). 2. 3. Remov Clean n e 4 wing screws (1) and re et (2). 4. Check t he front and rear surfaces of oil cooler fins (3), radiato fins (4), aftercooler fins (5), Air con ditioner condenser fins (6) and fuel cooler fins (7). If there is a ny mud, dirt, or leaves stuc to the fi Steam ns, blow the dirt off with co or water may be used i r, when carrying out mpressed air.
nstead of compressed air powerful steam cleanin of the heat exchang aftercooler, fuel cooler, ai sufficient distance from th Howeve (high-pressure machine wash) equipm conditio ent (radiator, oil cooler, ner condenser), maintain machine when carrying out the o (high-pressure machine wash) is peration. If steam cleanin carried out at close range fins of the heat exchang there is danger that the internal equipm ent may be deformed, and t his will cause early cloggin 5. and bre Check t akage. he rubber hose. Replace w ith a new one if the hose i found to have cracks or to be hard Also, ch eck hose clamps for loose 6. After co mpleting inspection and cl eaning, install net (2) to its original