. MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN SWING MACHINERY CASE WARNING under the drain underside to drain oil, to 93 Nm (4.5 to 9.5 4 - 76 EVERY 1000 HOURS MAINTENANCE Carry out the periodic mainte nance work o f every 100, 250 a nd 500 hours of operation at the same tim The parts and oil are at high tem perature after t he engin e is s topped , and may cause serious burn s. Wait for the tem perature to go d own befor e starting the ope R efill capa city: 2.0 liters (0 1. ntainer plug (P) at the bottom of the machine. 2. Loosen d rain plug (P) o n the machine and tight en it again after the draining. Tightenin g torque of drai 3.
Add the specified amount of engine oil through dipstick (G) rt. oil on the dipstick (G) with cloth. ert dipstick (G) into filler pipe, then remove it. insert po 4. Wipe off oil on the dipstic k (G) with clo 5. Fully ins ert dipstick (G) i nto filler pipe, t hen remove 6. The oil s hould be betwee n the H and L marks on di pstick (G). If the oil is below the L mark, add oil through the dipstick port. insertion 7. If the oil i s above the H m ark, drain the excess engi ne oil from drain plu g (P), and check the oil level a gain .