. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE pressure. REMARK 4 - 80 4. 5. Loosen bolt (2), then rem ove plate (3) on top of oil filler port (F). 6. Remove the cap from oil filler port (F), and release the internal 7. Loosen 3 bolts, then rem ove cover (4). When doing this, the cover may fly out under th e force of spring (5), so hold cover (4) down when removing th e bolts. ) and vlve (6), take out element (7). in diesel oil. 8. After removing spring (5 ) and vlve (6), take out elem ent (7 9. Clean the removed parts 10. Install the new element in the place where old elemen t (7) was installed.
Check the O-ring fitted t o cover (4), and if it is scratched or a new O-ring. (5) on top of the element. damaged, replace it with 11. Set valve (6) and spring 12. Set cover (4) in position, push it down by hand, and i nstall the cover (4) with the bolts. port (F). 13. Install the cap of oil filler 14. Install plate (3) on top of oil filler port (F) and secure it with bolt (2). Close mud cover (1). To bleed the air, start t he engine according to "STARTING 15. 16. To ENGINE (PAGE 3-129)" minutes. Stop the engine. and run the engine at low id le for 10 17. Operate the machine after h alting for more than 5 minute s to eliminate bubbles in the oil insid 18. Check for oil leakage an