Komatsu — EVERY 1000 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE REMARK It is not necessary to remove the plug at the top of the fuel runs out of fuel, use the same procedure to operate feed pump (4) and bleed the air. 11. Push in the knob of feed pump (4) and tighten it. 4 - 82 Replace inner s NOTICE filter cartridge with fuel. Do not fill the new Remove cap (B) a nd install the filter cartridge. 6. When installing , tighten until the packing surface contacts the seal surface of the filter holder, the n tighten it 3/4 of a turn. If the filter cartr idge is tightened too far, the packing will be damaged and this will lead to leakage of fuel.

If the filter cartridge i s too loose, fuel will also leak from the packing, so always tighten the correct amo 7. Set valve (1) a t the side of the fuel pre-f ilter cartridge to the open position 8. After completin g the replacement of filte r cartridge (2), bleed the air. Bleed the air as fol 9. Fill the fuel tan k with fuel (to the position where the float is at the highest 10. Loosen the kn ob of feed pump (4), pull and out until th e movement becomes he pre-filter and fu After the engin 12. After replacing the filter cartridge, start t he engine and run it at low idling Check for leaka ge of oil from the filter sea l surface.

If any oil is leaking, che ck the tightening of the f ilter cartridge. If there is still oil leakage, repeat Steps 2 - 4 to remove the filter cartridg e, and if any damage or embedded foreign materia l in the packing surface is found, replace it with a new cartri dge and repeat Steps 5 - 12 to install it.