. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 6. Clean the filter holder, coat the packing surface of the new filter cartridge thinly with oil, then install the filter cartridge to the filter holder. NOTICE 4 - 84 3. 4. 5. Open Set th Using and re the engin e contain a filter w move it. e hood. er to catch the fuel under the filter cartridge. rench, turn filter cartridge (2) counterclockwis (2 cartridges) Replac e inner se al (3) with a ne Do not fi ll the new filter c artridge wi Remove cap (B) an d insta ll the filter cartridge. 7. When installing , tight en until th e packing surface con tacts the seal surface of the filter h older, then tighten it 3/4 of a tu rn.
If the f ilter cartridge is tightene d too far, t he packing will be d amaged and this will lead t o leakage of fuel. If the filter c artridge i s too l oose, fuel will also l eak from th e packin g, so always tighten the co rrect amount. 8. Set va lve (1) at the si de of the fuel pre-filter cartridg e to the open position (O). the air. 9. After c ompletin g the r eplacem ent of filte r cartridge ( 2), bleed