Komatsu — LOCATIONS

. ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT Selector Valve Lock Pin (rear is locked) full position NOTICE 6 - 6 This valve (2) sw itches the flow of hydraulic Position (a): Whe n using breaker Position (b): Whe n using general attachmen t (crus her, etc. Attachment Contr This pedal (3) is used to operate t This pin (4) locks the control peda Position (a): Lock Position (b): Only front of pedal ca n be operated to full position Position (c): Both front and rear of peda l ca n be op erated t When not usin g the attachment , set t he l ock pin to position (a).

When using th e breaker, use th e working mode selector switch on the monitor switch portion to set th e working m ode to B mode, and set the loc k pin to position (b) when using th e pedal . When using th e crusher, use th e working mode selector switch on the monitor switch portion t o set the working mode to A TT mode, and set the lock pin to po sition (c) when u sing the pedal. When using the breaker, if the lock pin is set t o positio n (c) and the pedal is operated in direction ( D), it will cause dama ge o defective operat ion of the breaker. To prevent this, wh en using the breaker, always set the lock pi n to position Before changing the position of the lock pin, s top the