Komatsu — HYDRAULIC CIRCUIT

. ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT HYDRAULIC CIRCUIT (A) Plug an air bleeding procedure for the 3) After completing the bleeding of the air, stop the engine, has been spilled. 6 - 8 Hydraulic Circuit Connectio When connecting the attachme nt, connect the hydraulic circui t as 1. Check that the stop valve is at the LOCK position, then remove the plug. Be careful not to lose or da mage any part that is removed 2. Connect the piping for th attachment maker. e attachment provided by the the The dimensions on the stop per valve side are as indicate d at right. For those on the att ach manufacturer of attachment 3.

After connecting the piping, 1) Start the engine, referrin 3-129)", and run it at minutes. Then proceed t 2) Run the engine at low i circuit is completely rem pedal repeatedly (appro After connecting the piping, 1) Start the engine, referrin bleed the air from the circuit. g to "STARTING ENGINE (PAGE low idle for the subsequent 10 o the next work. dle until the air in the attachment 2) Run the engine at low i oved, then operate the attachment x. 10 times) to bleed the air. NOTICE If the attachment maker specifies I f th attachment itself, follow the specifie inutes before starting operations. bles in the oil inside the tank. 4) Check that there is no oi l leakage, and wipe off any oil that