. ATTACHMENTS AND OPTIONS CHANGING MACHINE CONTROL PATTERN (IF PATTERN CHANGE VALVE EQUIPPED) CHANGING MACHINE CONTROL PATTERN (IF PATTERN CHANGE VALVE EQUIPPED) WARNING 3. Follow the steps explained below, when switching the patterns. 1) Loosen wing bolt (1). 2) Move lever (2) with a special tool to select either ISO pattern (A) or Backhoe pattern (B). 3) After the switching, tighten wing bolt (1). that the operating pattern has changed.
6 - 20 When changing the operating pattern of the machin e, set the machin e in the parking posture, stop the engine, check that the lock lever is at the L OCK position, then change the operating pattern To prevent personal injury caused by mistaken oper ation, test operate the machine and check that th e display on the operating pattern card is the s ame as the movement of the m If it is not the same, replace the operating pattern c ard immediately w ith the card that matches the When checking the movement of the machine, che ck carefully that t he surrounding area is safe, an CONTROL PATTERN CHANGE PROCE DURE 1.
After setting the machine in the parking posture, set the lock lever to the LOCK position, then stop the engine. 2. Open the inspection cover on the left side of the machine. The selector valve is inside. 1. After setting the machine in the parking post ure, set the lock lever to the LOCK position , then stop the engine. 2. Open the inspec tion cover on the left side of t he machine. Th 4. Change to an o perating pattern card (insert it in the holder) that matches the selected 5. Start the engine , set the lock lever to the FR EE position, operat e the work equipment le vers slowly, and check