Komatsu — The travel speed is slow, the thrusting force is weak, the uphill traveling power is weak, and th...

H-3 – a TROUBLESHOOTING OF HYDRAULIC, MECHANICAL SYSTEM (H MODE) 20-906 WA470-5H / WA480-5H ! Defective Clutch and ECMV Specifying Method (Check by Failure Code) ★ For the checking method of failure code display, see the paragraph of "Special Functions of Machine Monitor." ★ When replacing the ECMV for diagnosis, remove mud and dust around the ECMV com- pletely and clean it, and then tighten the mounting bolt with the specified torque. ★ For the following diagnoses, start the engine and select the manual mode:

Table of Applicable Clutches Clutch F R 1st 2nd 3rd 4th In the Automatic Mode # N In the Manual Mode $ $ $ $ F1 # # F2 # # Speed F3 # # F4 # # Gear R1 # # R2 # # R3 # # R4 # # ★ When the gear speed is N in the manual mode, the clutch of the gear speed (Marked with O), to which the gear shift lever is set, is ON. Even if the gear shift lever is used when the gear speed is N, the clutch position cannot be changed.

Cause Transmission ECMV a b c d e f g h i j k l Wear or seizure of F clutch disk or wear of piston seal Wear or seizure of R clutch disk or wear of piston seal Wear or seizure of 1st clutch disk or wear of piston seal Wear or seizure of 2nd clutch disk or wear of piston seal Wear or seizure of 3rd clutch disk or wear of piston seal Wear or seizure of 4th clutch disk or wear of piston seal Defective operation of F clutch ECMV (Fill switch) Defective operation of R clutch ECMV (Fill switch) Defective operation of 1st clutch ECMV (Fill switch) Defective operation of 2nd clutch ECMV (Fill switch) Defective operation of 3rd clutch ECMV (Fill switch) Defective operation of 4th clutch ECMV (Fill switch) No.

Remedy Diagnosis Failure Code X X X X X X X X X X X X 1 A The code is not displayed at R1~R4 but is displayed at F1~F4 15SALI $ $ B When the failure code is 15SALI after the diagnosis in B, the failure code comes not to be displayed when the F fill switch connector (CN-F.SW) is disconnected. When the failure code is 15SALH, the failure code comes not to be displayed when the ECMV is replaced with any one other than F clutch ECMV 15SALH $ 2 A The code is not displayed at F1~F4 but is displayed at R1~R4 15SBLI $ $ B When the failure code is 15SBLI after the diagnosis in B, the failure code comes not to be displayed when the R fill switch connector (CN-R.SW) is disconnected.

When the failure code is 15SBLH, the failure code comes not to be displayed when the ECMV is replaced with any one other than R clutch ECMV 15SBLH $ 3 A The code is not displayed at F2, F3, and F4 but is displayed at F1 15SELI $ $ B When the failure code is 15SELI after the diagnosis in B, the failure code comes not to be displayed when the 1st fill switch connector (CN-1.SW) is discon- nected.

When the failure code is 15SELH, the failure code comes not to be dis- played when the ECMV is replaced with any one other than the 1st clutch ECMV 15SELH $ 4 A The code is not displayed at F1, F3, and F4 but is displayed at F2 15SFLI $ $ B When the failure code is 15SFLI after the diagnosis in B, the failure code comes not to be displayed when the 2nd fill switch connector (CN-2.SW) is discon- nected.

When the failure code is 15SFLH, the failure code comes not to be dis- played when the ECMV is replaced with any one other than the 2nd clutch ECMV 15SFLH $ 5 A The code is not displayed at F1, F2, and F4 but is displayed at F3 15SGLI $ $ B When the failure code is 15SGLI after the diagnosis in B, the failure code comes not to be displayed when the 3rd fill switch connector (CN-3.SW) is discon- nected.

When the failure code is 15SGLH, the failure code comes not to be dis- played when the ECMV is replaced with any one other than the 3rd clutch ECMV 15SGLH $ 6 A The code is not displayed at F1, F2, and F3 but is displayed at F4 15SHLI $ $ B When the failure code is 15SHLI after the diagnosis in B, the failure code comes not to be displayed when the 4th fill switch connector (CN-4.SW) is discon- nected.

When the failure code is 15SHLH, the failure code comes not to be dis- played when the ECMV is replaced with any one other than the 4th clutch ECMV 15SHLH $ Clutch F R 1st 2nd 3rd 4th Gear Speed N In the Automatic Mode # In the Manual Mode $ $ $ $ F1 # # F2 # # F3 # # F4 # # R1 # # R2 # # R3 # # R4 # #