Komatsu — The boom moves slowly or the boom rising force is insufficient

H-16 TROUBLESHOOTING OF HYDRAULIC, MECHANICAL SYSTEM (H MODE) H-16 The boom moves slowly or the boom rising force is insufficient 20-920 WA470-5H / WA480-5H ! Inspection before diagnosis • Is the stroke of the boom control lever appropriate? Check of Abnormality • Rising force and speed problem are closely related, and this problem oc- curs as insufficient rising speed at first. Measure the boom rising speed when the boom is loaded and make sure referring to the criterion table that the speed is abnormal.

Cause Tank Pump Steering Valve PPC Valve Work Equipment Valve Cylinder Cutoff Valve a b c d e f g h i Clogging of pump suction port or mixing of much air in oil The hydraulic pump and the switch pump are defective Defective operation of demand spool Defective operation of relief valve Defective operation of spool Defective operation or improper adjustment of main relief valve Wear or breakage inside valve body (Boom spool) Damage of boom cylinder piston seal Defective operation or improper adjustment of cutoff valve No.

Remedy Diagnosis C X ∆ X ∆ X ∆ X ∆ X A X X ∆ X ∆ X 1 The bucket tilting force and speed are abnormal, and the boom rising speed is slow $ $ $ 2 The bucket tilting force and speed are normal, and the boom rising speed is slow $ $ $ 3 When the oil temperature rises in No.

1, the boom speed becomes very slow $ 4 The hydraulic pump is causing an abnormal noise $ $ 5 When the engine is at full throttle, the steering operation is light and too fast $ 6 When the engine is at full throttle, the steering operation is heavy and slow $ $ 7 Large hydraulic drift of cylinder $ $ 8 The relief oil pressure from the relief valve of the work equipment valves is low $ $ $ $ 9 The relief oil pressure from the relief valve of the work equipment valves is too high $