Environment and safety Before starting Certification Ensure that all guards are in place before starting the engine. Ensure that no tools or other objects have been left on the engine. An emissions certified engine fulfils the emis- sions requirements for a particular range of ap- plication. WARNING! On each emissions certified engine there is a la- bel which shows which requirements the engine fulfils. Scania guarantees that each such engine fulfils the emissions requirements for the range of application for which it is certified. The air filter must be fitted before starting the en- gine.
Otherwise there is a risk of objects being sucked into the compressor impeller or of injury if you come into contact with the air filter. The following are required for the certified en- gine to fulfil the emissions requirements once it has been taken into service: Maintenance is to be carried out in accord- ance with the instructions in this Operator's manual. The maintenance and repair of injection equipment are to be carried out by a qualified workshop or person. The engine may only be modified with equip- ment that has been approved by Scania. Seals may be broken and setting data edited only once approval has been granted by Sca- nia.
Modifications may be made by author- ised personnel only. Modifications affecting the exhaust and in- take systems must be approved by Scania. Otherwise, the instructions in the Operator's manual for the running and maintenance of the engine shall apply. The safety precautions should be observed. IMPORTANT! For Scania to guarantee that the engine corre- sponds to its certified configuration, and take re- sponsibility for any damage and injuries that occur, maintenance must be carried out as above. OPM 300 en-GB 11 © Scania CV AB 2015, Sweden