TROUBLESHOOTING / Troubleshooting A TROUBLESHOOTING A PROCEDURE Refer to troubleshooting A procedure in case any fault codes are displayed after diagnosing by using Dr. ZX or the service menu of monitor unit. How to Read Troubleshooting Flow Charts After completing the checking and/or measuring procedures in box (1), select YES (OK) or NO (NOT OK) and proceed to box (2) or (3). (1) Instructions, reference, and/or inspection methods and/or measurements are occasionally described under the box. If incorrectly checked or measured, not only will troubleshooting be unsuccessful but also damage to the components may result. · Key switch:
ON Refer to “Electrical System Inspection” Group (Group 7) for descriptions in the dotted-line box. Use Dr. ZX for descriptions in the double-line box. Causes of machine problems are stated in the thick-line box. Scanning quickly through the thick-line boxes allows you to estimate the possible causes before actually following the flow chart. NOTE: Harness end connector viewed from the open end side by the all connectors image shown in this section. Harness Open End Side Harness End Connector T158-05-03-001 T5-5-1 YES(OK) (2) (3) NO(NOT OK)