hitachi — Relationship between Machine Trouble Symptoms and Related Parts

TROUBLESHOOTING / Troubleshooting B T5-6-12 Item Parts Function Symptoms in control system when trouble occurs. Symptoms in machine operation when trouble occurs. Pressure Sensor (Arm Roll-In) • Monitors arm roll-in pilot pressure in order to control HP mode, arm flow rate, and arm regeneration controls. • HP mode control Engine speed does not increase when operating arm roll-in. • Arm regeneration control Arm regeneration is not op- erated during combined op- eration of arm roll-in and swing. • Digging regeneration control Arm operation speed is slightly slow when operating digging during combined op- eration of boom raise and arm roll-in.

• Auto-power lift control Pressure increases when operating digging during combined operation of boom raise and arm roll-in. • When operating arm roll-in with the HP mode switch ON, engine speed does not in- crease. • During combined operation of arm roll-in and swing, arm speed is slow. Pressure Sensor (Auxiliary) (Optional) • Monitors attachment pilot pressure when attachment is installed in order to control attachment operation speed increase, pump 1 flow rate limit, pump 2 flow rate limit and auxiliary flow rate con- trols. • Attachment Open part: Maximum • Pump 1, 2 flow rate limits are ineffective.

• During combined operation of attachment and front attach- ment, front attachment speed is slow. • Pump 1, 2 flow rates are not limited at attachment mode. Torque Control Solenoid Valve • Supplies control pressure to pumps 1 and 2 in order to control speed sensing and slow speed torque increase controls. • High current: Pump torque is kept maximum. The engine stalls or llug-down is re- markable at high loaded. • Low current: Pump torque is kept minimum. • High current: If pump torque is maximum at low idle, the en- gine stalls or llug-down oc- curs. • Low current: The machine operation is totally slow.