hitachi — Engine System Troubleshooting

TROUBLESHOOTING / Troubleshooting B ENGINE SYSTEM TROUBLESHOOTING E-1 Starter does not rotate. Related MC Fault Code: None IMPORTANT: As electric current from the key switch is not routed to starter relay 2 with the pilot shut-off lever in ON position, the starter does not rotate. (Refer to “Elec- trical System”.) This trouble has nothing to do with the electronic control system such as MC. Check the wiring connections first. Key Switch: Battery Relay: Switch starter cut relay with other general re- lay. Check if starter rotates. YES YES Check if voltages at terminals #5 and #6 in key switch are 24 V. · Key switch: START · Monitor unit: Primary screen · Key switch: START · Monitor unit:

Primary screen Check for continuity between positive ter- minal in battery and terminal #1 in key switch. Check if primary screen or password input screen is dis- played on monitor unit. NO NO Faulty harness between battery and key switch. · Key switch: ON NOTE: As for the password setup type machine, the password input screen is displayed. Check if battery volt- age and electrolyte density are normal, and fusible link (45 A) is not blown. Open circuit in harness between monitor unit and key switch. NO NO · Voltage: 24 V or more Density: 1.26 or more · Key switch: ON Faulty battery. Faulty fusible link. NO Terminal A T178-05-04-001 T105-07-04-002 T5-6-58 YES Faulty starter cut relay.

Disconnect starter cut relay. Check if voltage at terminals #1 and #3 of harness end of connector is 24 V. · Key switch: START · Monitor unit: Primary screen YES Faulty key switch. Disconnect connector monitor-A in monitor unit. YES Check if voltage be- tween terminal #A7 of harness end of con- nector and machine is 24 V or more. YES Faulty monitor unit.