TROUBLESHOOTING / Troubleshooting B E-6 Faulty HP mode Even if power mode switch is turned to the HP mode position, HP mode is not operated. (General mode normally operates.) Related MC Fault Codes: 11004-2, 11200-3, 11200-4, 11202-3, 11202-4, 11302-3, 11302-4, 11303-3, 11303-4 The sensors detect the conditions necessary to operate HP mode. Therefore, if any of these sen- sors fails, HP mode becomes ineffective. Pressure sensors (arm roll-in and boom raise) and pump 1 and 2 delivery pressure sensors are also engaged in the HP mode control. However, if these sensors fail, other operating functions will be also affected.
Refer to the pages for HP Mode Control in the SYSTEM / Control System group in the T/M (Op- erational Principle). Check the wiring connections first. NO Faulty power mode switch or open circuit in harness between power mode switch and MC. Monitor power mode switch. Check if indication HP is highlighted when power mode switch is turned to “HP mode”. NO Faulty MC. · Monitor item: E/P/HP mode switch YES NO Faulty corresponding sensor, or open circuit in harness between MC and sensor. · Fault code: 11200-3 11200-4: Pump 1 delivery pressure sensor 11202-3, 11202-4: Pump 2 delivery pressure sensor 11302-3, 11302-4: Pilot pressure sensor (boom raise) 11303-3, 11303-4:
Pilot pressure sensor (arm roll-in) Refer to fault code 11004 in Troubleshooting A. YES T5-6-66 Check if fault code is displayed. Check if fault code 11004-2 is displayed at YES the same time.