hitachi — Engine System Troubleshooting

TROUBLESHOOTING / Troubleshooting B E-12 Engine speed does not increase even if at- tachment is operated in attachment mode. Related MC Fault Code: 11004-2, 11918-2 In case trouble symptoms E-1 to E-11 are recog- nized, perform the troubleshooting of these trou- bles first. Even if the failure in pressure sensor (auxiliary) and power mode switch may have relevance to the malfunction of attachment operation speed increase control. However, if these sensor and switches fail, other operating functions will also be affected. Refer to the pages for Attachment Operation Speed Increase Control in the SYSTEM / Control System group in the T/M (Operational Principle).

Check the wiring connections first. T5-6-79 NO Normal (Set to “Increase (+)”.) Check if attachment speed adjustment NO has been set to “In- crease (+)” on “Pa- YES rameter Change” in Monitor attachment To A Dr. ZX. pilot pressure. Check if pressure Check if attachment YES varies in response to speed adjustment lever stroke. Faulty auxiliary pressure has been set to “De- sensor. crease (-)” on “Pa- · Monitor item: Att. NO rameter Change” in control pilot pressure Dr. ZX.

Normal (If P speed is set to decrease”, this control YES system is deactivated.) NO Normal (Set to “Increase (+)”.) Normal (If P speed is set to decrease”, this control system is deactivated.) Fault code 11004-2 or A 11918-2 is displayed. YES Refer ti fault code 11004 in Troubleshooting A. NO