TROUBLESHOOTING / Troubleshooting B E-14 Engine stalls during operation under ad- verse condition such as at high altitude. Related MC Fault Code: 11004-2, 11100-2, 11910-2, 11401-2, 11401-3, 11401-4 If speed sensing control is not operated, the en- gine will stall under adverse operating conditions. Check the wiring connections first. Test Harness (ST 7226) When operating corresponding control lever and switch: ON 4 3 50 1 1 50 150 2 2 50 T107-07-06-015 Check if fault code 11401-2, 11401-3 or 11401-4 is displayed. Disconnect harness of torque control sole- noid valve. Connect test harness (ST 7226) between solenoid valve and harness. Check if test harness lamp comes ON.
NO Monitor torque control solenoid valve output. Install pressure gauge to output port so that pressure is measured by pressure gauge and Dr. ZX. Check if both meas- ured pressure values by pressure gauge and Dr. ZX vary identically. NO Monitor actual engine speed. Check if engine speed is abnormal. NO · Monitor item: Pump torque proportional solenoid valve output · Refer to the Operational Performance Test section. · Monitor item: Engine actual speed · Possible to display by service menu and monitoring in monitor unit. YES Refer to fault code 11004 in Trouble- shooting A. Check if fault code 11004-2 or 11100-2 is displayed. YES Check if fault code 11910-2 is displayed.
NO T5-6-82 YES Faulty torque control solenoid valve. Disassemble and check regulator. YES YES Refer to Engine Trou- bleshooting Manual. Faulty MC. NO