TROUBLESHOOTING / Troubleshooting B F-13 Attachment speed is fast during combined operation of attachment (optional) and front attachment (when secondary crusher or primary crusher is used). Related MC Fault Code: None Check the wiring connections first. Connector (Harness end of connector viewed from the open side) Open circuit in har- ness between MC and pressure sensor (aux- iliary). Disconnect connec- tor MC-D in MC. Check for continuity between terminal #D5 of harness end of connector and terminal #2 of har- ness end of connec- tor in pressure sen- sor (auxiliary). NO YES Disconnect connector in pressure sensor (auxiliary).
Check if voltage be- tween terminals #1 and #3 of harness end of connector is 5 ± 0.5 V. Check if voltage be- tween terminals #D5 of harness end of connector MC-D and machine is 0 V. YES NO · Key switch: ON · Key switch: ON Switch pressure sensor (auxiliary) with other pressure sensor. Check if fault code for switched pres- sure sensor is dis- played. Check if voltage be- tween terminals #1 of harness end of con- nector in pressure sensor (auxiliary) and machine is between 0.25 and 4.75 V. YES Open circuit in har- ness between MC and pressure sensor (aux- iliary) (terminal #3). NO Open circuit in har- ness between MC and pressure sensor (aux- iliary) (terminal #1). · Key switch:
ON NO Faulty pressure sen- sor (auxiliary). YES Pilot Pressure Sensor (Auxiliary) Pilot Pressure Sensor (Arm Roll-Out) #A7 #A23 MC Connector MC-A T1V1-05-07-102 Auxiliary Flow Rate Control Solenoid Valve T183-05-04-008 MC Connector MC-D #D5 T1V1-05-04-003 T183-05-04-009 #D9 T5-6-114