TROUBLESHOOTING / Troubleshooting B STEP 5 Component Operation Check Each component operation is checked by performing pattern operation. Each time the fresh air vent switch is pushed, the component to be checked is selected in order. Check which component has been selected by re- ferring to No. indicated on the LCD. (Refer to table 1.) Operating pattern of the selected component is shifted at an interval of 10 seconds. Operating pat- tern is cycled. (Refer to table 1.) Air Conditioner Switch AUTO Switch Fan Switch LCD T178-05-08-001 Fresh Air Vent switch OFF Switch NOTE: The components other than selected oper- ate under the standard conditions (shown by marks* in table 1).
Select the next step in order to be performed by operating the switches as follows: Push the AUTO switch and upper side of fan switch: To proceed to “STEP 6-1”. Push the A/C switch and upper side of fan switch: To proceed to “STEP 6-2”. Push the lower side of fan switch: To return to “STEP 4.” Keep pushing the OFF switch for more than 3 seconds: Deactivate the self-diagnostic system. (Normal function is resumed.) Table 1 T5-6-139 Component Indication on LCD Operation Pattern Remarks Air Mix Damper 51 Controls opening extent of air mix damper: 0% (fully closed) → 50%*→ 100% (fully opened) 0%, 50%, 100%: “C”, “5” and “H” are in- dicated next to the decimal point respec- tively.
Fan 52 Controls air flow volume: Lo → M(Lo) → M(Hi) → Hi Indicators corresponding to air flow vol- ume light. Air Vent Location 53 Selects air vent: Front*→ Front/Rear → Front/Foot → Foot Indicator corresponding to selected air vent lights. Fresh / Circulation Air Vent Selection 54 Select Ventilation Mode: Circula- tion* → Fresh Indicator corresponding to selected mode light. Air Conditioner 55 Turns air conditioner switch: ON* → OFF ON: Indicator lights. OFF: Indicator is extinguished.