TROUBLESHOOTING / Troubleshooting B EMERGENCY BOOM LOWERING PRO- CEDURE CAUTION: Prevent personal injury. Confirm that no one is under the front attachment before starting the procedure below. If the engine stalls and cannot be restarted, lower the boom to the ground referring to the emergency boom lowering procedure stated below. 1. Loosen lock nut (1) in the control valve at the right. Loosen screw (2) one half of a turn. The boom lowering speed can be somewhat adjusted by loosening screw (2) more. IMPORTANT: Lock nut (1) and screw (2) are lo- cated under the solenoid valve. Pay attention to the screw turns. 2.
After the boom is lowered, tighten screw (2) and tighten lock nut (1) to the specifications below. Lock Nut (1) Emergency Valve T1V1-05-04-005 : 13 mm : 13 N m (1.3 kgf m, 9.4 lbf ft) Screw (2) : 6.9 N m (0.7 kgf m, 5.0 lbf ft) : 4 mm (Hexagonal wrench) NOTE: Excessive leakage may result if the screw and the lock nut are tightened insufficiently. Retighten the screw and the lock nut to specifications. T178-05-04-003 T5-6-155 Emer gency Valve 1 2