TROUBLESHOOTING / Troubleshooting B T5-6-159 Position to be checked Remedy Key signal line, alternator signal line Check if voltage between terminal #C7 (power ON signal line) of connector ICF-C in ICF and machine is 24 V or more. Communication line between monitor unit and ICF (CAN bus line) • Check for continuity between terminals #C5 of connector ICF-C in ICF and terminals #B7 of connector monitor-B in monitor unit. (Refer to T5-6-161.) • Check for continuity between terminals #C11 of connector ICF-C in ICF and terminals #B6 of connector monitor-B in monitor unit. (Refer to T5-6-161.) • Check for shorted circuit in harness between CAN circuit in ground circuit.
(Refer to T5-5-62.) • Check for shorted circuit in harness between CAN circuit in power circuit. (Refer to T5-5-65.) • Check for shorted circuit in harness between CAN circuit in key signal circuit. (Refer to T5-5-68.) • Check for shorted circuit in CAN harness. (Refer to T5-5-70.) Communication line between ECM and ICF (CAN bus line) • Check for continuity between terminals #C5 of connector ICF-C in ICF and terminals #18 of connector in ECM. (Refer to T5-6-160.) • Check for continuity between terminals #C11 of connector ICF-C in ICF and terminals #37 of connector in ECM. (Refer to T5-6-160.) • Check for shorted circuit in harness between CAN circuit in ground circuit.
(Refer to T5-5-62.) • Check for shorted circuit in harness between CAN circuit in power circuit. (Refer to T5-5-65.) • Check for shorted circuit in harness between CAN circuit in key signal circuit. (Refer to T5-5-68.) • Check for shorted circuit in CAN harness. (Refer to T5-5-70.) Communication line between monitor unit and ICF (CAN bus line) • Check for continuity between terminals #C5 of connector ICF-C in ICF and terminals #B7 of connector monitor-B in monitor unit. (Refer to T5-6-161.) • Check for continuity between terminals #C11 of connector ICF-C in ICF and terminals #B6 of connector monitor-B in monitor unit.
(Refer to T5-6-161.) • Check for shorted circuit in harness between CAN circuit in ground circuit. (Refer to T5-5-62.) • Check for shorted circuit in harness between CAN circuit in power circuit. (Refer to T5-5-65.) • Check for shorted circuit in harness between CAN circuit in key signal circuit. (Refer to T5-5-68.) • Check for shorted circuit in CAN harness. (Refer to T5-5-70.)