E EMD00010 STEERING FRICTION ADJUSTMENT (for Tiller control model) A friction device provides resistance to steering movement. This is adjustable for operator preference. An adjusting screw/bolt is located on the swivel bracket. 408011 To increase the resistance: Turn the adjusting screw/bolt clockwise. To decrease the resistance: Turn the adjusting screw/bolt counter- clockwise. w Do not overtighten the friction screw/bolt. If there is too much resis- tance, it may be difficult to steer, which could result in an accident. EMU01297 TRIM ANGLE ADJUSTING ROD The position of the trim angle adjusting rod determines the minimum trim angle of the outboard motor in relation to the transom.
404013** EMD44110 TILT LOCK MECHANISM (for Manual tilt model) The tilt-lock mechanism is used to pre- vent reverse thrust from the propeller lift- ing the outboard motor when reversing. To lock it, set the tilt-lock lever in the Lock position. To release it, place the tilt-lock lever in the Tilt position. 402014* q 1 Tilt-lock lever 2-6