E Break-in (running-in) time:10 hours Break-in (running-in) premix ratio: Refer to “Gasoline/Petrol and Oil Mixing”. EMU00226 Run the engine under load (in gear with a propeller installed) as follows. 1) First 10 minutes: Run the engine at the lowest possi- ble-speed. A fast idle in neutral is best. 2) Next 50 minutes: Do not exceed half throttle (approxi- mately 3,000 r/min). Vary engine speed occasionally. If you have an easy-planing boat, accelerate at full throttle onto plane, then immediately reduce the throttle to 3,000 r/min or less. 3) Second hour: Accelerate at full throttle onto plane, then reduce engine speed to three- quarter throttle (approximately 4,000 r/min).
Vary engine speed occasional- ly. Run at full throttle for one minute, then allow about 10 minutes of opera- tion at three-quarter throttle or less to let the engine cool. 4) Third through tenth hours: Avoid operating at full throttle for more than 5 minutes at a time. Let the engine cool between full-throttle runs. Vary engine speed occasionally. 5) After the first 10 hours: Operate the engine normally. Use the standard premix ratio of gasoline : Oil. (Refer to “Gasoline/Petrol and Oil Mixing”.) 3-9