Yamaha Motor Corporation, USA 9.9A/15A — Yamaha Motor Corporation, USA 9.9A/15A User Manual

E ADJUSTING TRIM ANGLE EMU00951 Manual tilt model There are 4 or 5 holes provided in the clamp bracket to adjust the outboard motor trim angle. 1) Stop the engine. 2) Remove the trim angle adjusting rod 1 from the clamp bracket while tilting the motor up slightly. 3) Reposition the rod in the desired hole. To raise the bow (“trim-out”), move the rod away from the transom. To lower the bow (“trim-in”), move the rod toward the transom. Make test runs with the trim set to differ- ent angles to find the position that works best for your boat and operating condi- tions. w 404013* q 8 Stop the engine before adjusting the trim angle.

8 Use care to avoid being pinched when removing or installing the rod. 8 Use caution when trying a trim position for the first time. Increase speed gradu- ally and watch for any signs of instabili- ty or control problems. Improper trim angle can cause loss of control. NOTE: The outboard motor trim angle can be changed approximately 4 degrees by shifting the trim adjusting-rod one hole. 3-18