E EMU00338* Flushing Cooling System and Fogging Engine Cooling system flushing is essential to prevent the cooling system from clogging up with salt, sand, or dirt. In addition, fog- ging of the engine is mandatory to pre- vent expensive engine damage due to rust. Perform the flushing and fogging at the same time. w 8 Do not tough or remove electrical parts when starting or during operation. 8 Keep hands, hair and clothes away from flywheel and other rotating parts while engine is running. EMU00994* 8 Flushing in a Water Tank c C If the fresh water level is below the level of the anti-cavitation plate, or if the water supply is insufficient, engine seizure may occur.
1) Remove the engine top cowling. 2) Install the outboard motor on the water tank. 3) Fill the tank with fresh water to above the level of the anti-cavitation plate. 4) Remove the cap a for fogging on the silencer cover. 5) Run the engine at a fast idle for 10~15 minutes. 6) Just prior to turning off the engine, quickly spray “Yamaha Stor-Rite Engine Fogging Oil” (Part No. LUB- STRRT-12-00) into the silencer cover. When properly done, the engine will smoke excessively and almost stall. 7) Remove the motor from the water tank. 8) Install the cap and the top cowling. a q w 605024 1 Water surface 2 Lowest water level 4-5