V-MAC Co-Pilot Operator's Manual 25 The aftertreatment diesel particulate filter (DPF) smart switch is a three-position rocker switch where the UP position is momentary, the MIDDLE position is neutral (standby mode) and the DOWN position is locked. The switch allows the operator to interface with the vehicle's exhaust aftertreatment system. The switch has several functions as outlined below. Indicates that a an aftertreatment DPF regeneration is needed or has started when the icons on the switch are illuminated. Indicates that a regeneration has been stopped when the DOWN position of the switch is pressed, locked and illuminated.
Stops a regeneration event when the DOWN position of the switch is pressed, locked and illuminated. Starts an aftertreatment DPF manual regeneration event when the switch is momentarily pressed to the UP position. Goes into standby mode and waits for regeneration when the switch is in the MIDDLE position. C0035425 Figure 15 DPF Smart Switch For additional information on the Aftertreatment DPF Smart Switch and Regeneration, please refer to “EXHAUST AFTERTREATMENT SYSTEM”, page 26.