V-MAC Co-Pilot Operator's Manual 29 Aftertreatment DPF Inhibit/Stop Regeneration Aftertreatment diesel particulate filter (DPF) regeneration, whether the moving or parked variety, can be stopped if the vehicle is equipped with a DPF Smart switch (refer to “Aftertreatment DPF Smart Switch”, page 24 for more information). A regeneration should be stopped only when necessary. To stop a regeneration that is in progress, press the DPF Smart switch to the DOWN position. The switch will lock into the DOWN position, and the icon on the bottom of the switch will be illuminated to indicate regeneration has been stopped.
C0035426 Figure 16 Inhibit/Stop Regeneration CAUTION CAUTION When the DPF Smart Switch is pressed to the DOWN position, the switch will remain locked in this position and prevent aftertreatment DPF regeneration from occurring. Therefore, it is important to press the switch back to the middle position and to return it to standby mode when safe to do so. Failure to set the switch back to the MIDDLE position may result in engine derate, a clogged Aftertreatment Diesel Particulate Filter (DPF), damage to the filter and engine shutdown.
Failure to perform a aftertreatment DPF regeneration in a timely manner may result in engine derate, a clogged or damaged DPF, damage to the filter and engine shutdown. If the operator stops or inhibits regeneration repeatedly, the DPF will begin to clog with soot and engine exhaust gas pressure will increase. Eventually the engine will derate and ultimately shut down. Below is a quick look at the type of regenerations, conditions of the exhaust aftertreatment system and the action to be taken.