Mack Trucks — Mack Trucks V-MAC IV Electronic Vehicle Management System Manual

V-MAC Co-Pilot Operator's Manual 51 Once the above conditions are satisfied, activate the cruise control as follows. 1 Move the Speed Control ON/OFF switch to the ON position. 2 At the desired road speed, press and release the SET switch. The vehicle will maintain at the set speed. Note: Pressing the top of the Speed Control ON/OFF switch activates, or turns the switch ON. Pressing the bottom of the switch deactivates, or turns the switch OFF. Note: To shift, simply disengage the clutch, change gears, then re-engage the clutch. Cruise control will resume automatically if programmed to Auto Resume. When double clutching, DO NOT bring the clutch pedal to the fully engaged position.

CAUTION Transmission gear changes must not be made without the use of the clutch while in the cruise control mode. Failure to use the clutch will cause the engine speed (RPM) to increase to the high idle limit, which may cause severe powertrain damage. W2076078 Figure 23 Speed Control On/Off and Set/Decel Switches