Mack Trucks — Mack Trucks V-MAC IV Electronic Vehicle Management System Manual

V-MAC Co-Pilot Operator's Manual 65 W2076074 Figure 27 Speed Control Switches Note: If the idle speed does not drop to 550 RPM after meeting the requirements listed, there may be other possible problems which will not allow the idle to be reset. Refer to the vehicle management and control (V-MAC) IV Service Manual for troubleshooting procedures. 1 Depress and hold the accelerator pedal until the desired engine speed is reached. To complete the resetting of the idle speed, continue as follows: 2 Use the speed control switches to adjust idle speed. 3 Depress and release the clutch pedal to store idle speed.

This speed is now locked into vehicle management and control (V-MAC) IV as the low idle speed. Note: To detect a drop when resetting the idle, it is recommended that the low idle speed be set to a speed greater than 500 RPM. Smart Idle Elevated Idle RPM Time This feature will discontinue a ramp up for a period of time when the engine speed (RPM) reaches its target. The range of time can be set between 0 and 1092 minutes, with a default setting of 30 minutes.