72 V-MAC Co-Pilot Operator's Manual Mi/h Output This is a 50% duty cycle, 5-volt TTL-compatible, square-wave signal that is calibrated to provide a standard pulse rate of 30,000 pulses per mile. Note: TTL compatibility of this output may be affected by other devices connected to this output. Maximum rated current of the TTL output is 10 mA. Total current draw of all devices connected to this output must not exceed 10 mA at 4 volts. SAE/ATA J-1708 Posts (Series Link A and B) This is a serial communication interface. It conforms to the SAE/ATA J-1708 Recommended Practice for Serial Data Communications Between Microcomputer Systems In Heavy Duty Vehicle Applications.
CB Radio Power Jack (CB Radio +) (Located on Dashboard) This is a +12 volt, switched battery power connection. It is used to power the vehicle's CB radio. It is protected by a 15- amp circuit breaker and will supply power only when the ignition key is in the ON position. CB Radio Ground Jack (CB Radio −) (Located on Dashboard) This is a ground connection. It is used as a power return (−) connection for the vehicle's CB radio. See the following illustrations for the CTP and CXP electrical accessory connection points for electrical equipment panels.