STRUCTURE AND OPERATION Oil Pump 1 Crankshaft gear 2 Oil pump gear 3 Oil pump 4 Oil strainer 5 Relief valve A: To oil filter B: From oil pan C: To oil pan Oil pump 3 is a gear type. It is driven by rotation of the crankshaft via crankshaft gear 1 and oil pump gear 2 . Relief valve 5 is fitted to the oil pump. When the oil pump discharge pressure exceeds a specified level, the relief valve returns some of the engine oil to the oil pan, thus protecting the lubrication system from excessive oil pressure. 01476 Oil Filter 1 Full-flow filter element 2 Bypass filter element 3 Engine oil bypass alarm switch 4 Check valve 5 Bypass check valve A: To oil cooler B: From oil pump C:
To oil pan This oil filter is a spin-on paper-filter type incorporating full- flow filter element 1 and bypass filter element 2 . Engine oil bypass alarm switch 3 is fitted to the oil filter bracket. If clogging causes the pressure difference before and after the element to exceed a specified level, a valve inside the switch opens to allow oil to flow directly to the oil cooler. Check valve 4 is fitted to the inlet to prevent a reverse flow of oil out of the filter when the engine is stationary. In conjunction with this, bypass check valve 5 opens only when oil pressure in the bypass arrangement exceeds a specified level.
As a result, the oil level in the filter is kept constant and oil reaches all parts of the lubrication system quickly when the engine is started. 01477 12-4