12 12-17 Service standards Unit: mm (in.) Location Maintenance item Standard value Limit Remedy 5, 11 Clearance between drive gear shaft and inner diameter of cover [Basic diameter: 20 mm (0.787 in.)] 0.04 to 0.07 (0.00157 to 0.00276) 0.15 (0.00591) Replace 5, 6, 11 Clearance between drive gear shaft and inner diameter of case and cover [Basic diameter:
20 mm (0.787 in.)] 0.04 to 0.07 (0.00157 to 0.00276) 0.15 (0.00591) Replace 6, 11 Clearance between case and tooth tips of each gear 0.10 to 0.19 (0.00394 to 0.00748) 0.2 (0.00787) Replace Difference between height of each gear and depth of case 0.06 to 0.11 (0.00236 to 0.00433) 0.15 (0.00591) 8 Relief valve opening pressure 980 to 1175 kPa (10 to 12 kgf/cm2) [142 to 170 psi] – Replace 9 Relief valve spring load [Installed length = 30 mm (1.18 in.)] 84 N (8.6 kgf) [18.9 lbf] – Replace *2, A Backlash between oil pump gear and crankshaft gear 0.08 to 0.18 (0.00315 to 0.00709) 0.35 (0.0138) Adjust with shims Tightening torque Unit:
N·m (kgf·m) [lbf·ft] Location Parts to be tightened Tightening torque Remarks 4 Oil pump cover mounting bolt 25 ± 4.9 (2.5 ± 0.5) [18.4 ± 3.6] – N Service procedure G Inspection before disassembly Measure the backlash between oil pump gear A and crankshaft gear *2. If the amount of backlash exceeds the specified limit, adjust it with shims 12. Unit: mm (in.) Shim thickness Change in amount of backlash 0.1 (0.00394) 0.073 (0.00287) 0.2 (0.00787) 0.146 (0.00575) 01498 NOTE Shim 12 must have the same thickness on the left and right sides. Shim thickness Change in amount of backlash 0.1 (0.00394) 0.073 (0.00287) 0.2 (0.00787) 0.146 (0.00575)