Caterpillar — Caterpillar 99709-68120 — user manual

12 12-21 WARNING • Wipe up any spilled engine oil since it can cause a fire. • Do not touch oil when the engine is hot since it can inflict severe burns. CAUTION When pouring oil into the engine, take care not to spill any on the V-belts. Contact with oil could make the V-belts slip, rendering the cooling system less effective. Service standards Unit: MPa (kgf/cm2) [psi] Location Maintenance item Standard value Limit Remedy 3 Engine oil bypass alarm switch valve opening pressure 0.19 + 0.05 (1.9 + 0.5) [27.6 + 7.3] −0 −0 −0 – Replace Tightening torques Unit:

N·m (kgf·m) [lbf·ft] Location Parts to be tightened Tightening torque Remarks 1 Oil filter drain valve (Upward-facing) 30 ± 4.9 (3.0 ± 0.5) [22.1 ± 3.6] – 3 Engine oil bypass alarm switch 49 ± 4.9 (5.0 ± 0.5) [36.1 ± 3.6] – Lubricant Location Points of application Kinds Quantity 2 Apply thin film to oil filter gasket area P.12-10 Engine oil As required 7 Apply to O-rings Engine oil As required N Service procedure 3 Inspection of engine oil bypass alarm switch Carry out the following inspections and replace the engine oil bypass alarm switch 3 if the results are unsatisfactory:

• With no air pressure A applied to engine oil bypass alarm switch 3, check that there is no electrical continuity between the terminal ➀ and body ➁ of the engine oil bypass alarm switch. • Starting with pressure of 0 kPa (0 kgf/cm2) [0 lbf/in.2], gradually increase the air pressure A on engine oil bypass alarm switch 3. 11312 Note the air pressure when electrical continuity appears between the terminal ➀ and body ➁. Verify that this pressure conforms with the specified standard value. B: Air pressure gauge