Caterpillar — Caterpillar 99709-68120 — user manual

12 Lubricant and sealant 12-23 Location Points of application Kinds Quantity 2, 4, 11 Apply to O-rings Engine oil As required 13, 14 Wrap around thread of engine oil pressure gauge unit and engine oil pressure switch Teflon tape 3 1/2 turns N Service procedure G Cleaning • Check whether carbon deposits or sludge have accumulated in the oil passages of oil cooler element 6 and oil cooler cover 8 or in the oil cooler's bypass arrangement. Remove any deposits with cleaning sealant. • Clean out any water scale or fur that has accumulated in the oil cooler element 6 or oil cooler cover 8.

Gr 14 6 Inspection of oil cooler element Plug outlet A of oil cooler element 6 and connect a hose to the oil inlet. Then, immerse the oil cooler element in a tank of water. Apply the specified air pressure via the hose and check that no air leaks from the oil cooler element. If any air leaks, replace the oil cooler element. 01505 13 Engine oil pressure gauge unit If the engine oil pressure gauge unit 13 is installed horizontally, it must be fitted with its arrow pointing upward. 16886 14 Inspection of engine oil pressure switch Carry out the following inspections and replace the engine oil pressure switch 14 if the results are unsatisfactory.

• With no air pressure applied to the engine oil pressure switch 14, check that there is continuity between the terminal ➀ and body ➁. • Starting from 0 kPa (0 kgf/cm2) [0 lbf/in.2], gradually apply the air pressure A and check that the air pressure when the continuity between the terminal ➀ and body ➁ disappears is within the specification. 16202 B: Air pressure gauge