Caterpillar — Caterpillar 99709-68120 — user manual

ON-VEHICLE INSPECTION AND ADJUSTMENT 13-16 Checking and Adjusting Injection Timing Service standards Location Maintenance item Standard value Limit Remedy – Fuel injection timing (BTDC) 8, 9 ton models 11° – Adjust 10 to 15 ton models 13° – Adjust Tightening torques Unit: N·m (kgf·m) [lbf·ft] Location Parts to be tightened Tightening torque Remarks 1 Union nut (injection pipe mounting) 25 (2.5) [18.4] – 2 Bolt (injection pipe lock plate) Zexel, AD-type 3.4 to 4.9 (0.35 to 0.5) [2.88 to 3.61] – 3 Delivery valve holder Zexel, AD-type 49 to 54 (5 to 5.5) [36.1 to 39.8] – [Inspection] • From the injection pump's No.

1 cylinder, remove the injection pipe 1, lock plate 2, delivery valve holder 3, stopper 4, delivery valve spring 5, and delivery valve 6. • Fit the delivery valve holder 3. CAUTION Place all parts in gas oil after removal to keep them free of dust. 18934 • Fit an injection pipe 7 onto cylinder No. 1. Point the pipe's other end downward such that fuel flowing out can be seen clearly. • Rotate the crankshaft pulley clockwise (as seen from the front of engine) by at least 180° and bring cylinder No. 1 to approximately 30° BTDC on its compression stroke.

NOTE If the engine is turned in its reverse direction (when stopping the engine or by cranking), the automatic timer may stay in an 18935 advanced condition. This may not be cancelled by a slight forward rotation of the engine. Be sure to crank the engine forward manually by at least 180°. • Feed fuel into the injection pump using the priming pump 8. With fuel flowing out of the injection pipe 7, crank the engine slowly clockwise (as seen from the front of engine). NOTE Ensure that the stop lever 9 at the side of the governor is not in its STOP position. 18936 18936