ON-VEHICLE INSPECTION AND ADJUSTMENT Tighten each part to its specified torque. 01853 Checking and Adjusting Minimum and Maximum No-load Speeds Service standards 13-18 Location Maintenance item Standard value Limit Remedy – No-load minimum speed 690 + 30 rpm 0 – Adjust – No-load maximum speed 2350 + 100 rpm 0 – Adjust Start the engine and allow it to warm up before carrying out the following inspections. G No-load minimum speed [Inspection] Confirm that the control lever 1 is touching the idling set bolt 3. Then check that the minimum speed is up to specification. A: Idling position [Adjustment] If the minimum speed is out of specification, adjust it using the idling set bolt 3.
18231 G No-load maximum speed [Inspection] Confirm that the control lever 1 is touching the full-speed set bolt 2. Then, check that the maximum speed is up to specification. B: Full-speed position [Adjustment] If the maximum speed is out of specification, adjust it using the full- speed set bolt 2. NOTE Check that the engine does not stall and that no hunting occurs when the control lever 1 is moved quickly from the full-speed position to the idling position. If any abnormality is apparent, make adjustments within the specified range.