PRECAUTIONS FOR MAINTENANCE OPERATION Put alignment marks on part combinations before disassembly and arrange the disassembled parts neatly. This will help avoid mismating of the parts later. Put the alignment marks, punch marks, etc. where performance and appearance will not be affected. Cover the area left open after removal of parts to keep it free from dust. CAUTION 00017 Take care to avoid mixing up numerous parts, similar parts, left and right, etc. Keep new parts for replacement and original (removed) parts separate. Apply the specified oil or grease to U-packings, oil seals, dust seals and bearings during assembly. Use only the specified oil, grease, etc.
for lubricant, remove the excess immediately after application with a piece of waste, etc. CAUTION When the specified lubricant, fluid and sealant is not available, you may use an equivalent. 00018 Wear goggles when using a grinder or welder. Pay full attention to safety by wearing gloves when necessary. Watch out for sharp edges, etc. that might injure your hands or fingers. 00019 Before carrying out maintenance work on the electric system, disconnect the negative terminals of the batteries to prevent them from short-circuiting and burning-out. CAUTION Be sure to turn starter and lighting switches, etc.
off before disconnecting or connecting battery terminals, because the semiconductors can be damaged. 14184 00-6